Pages

Sabtu, 12 Maret 2016

Virginia Beach Optimist Project

Update from Als project at the end of April, 2013:

Well, I really have been working on this baby but being retired takes up a lot of time.  For the last month I have been trying to get her finally ready for the water.  What this in essence means is that i have sanded, and sanded and sanded some more.  I have used every type of sanding device that i know of including wrapping a piece of sand paper around a 3/8" drill bit and sanding along some of the rough fillets.  What I have definitely learned is that neatness is worth a lot and I was not as neat with the epoxy as I could and should have been.  This left a lot of high spots and some really sharp edges that could do a job on little knees.  They are all gone now and another thin coat of epoxy has been rolled over all the unpainted areas, mainly the inside of the boat but also the spruce part of the gunwales.  I plan on attaching strips of mahogany as the outer rub rail and just vanrishing these.  No epoxy.  They are almost ready to attach.

I have made my mast and gooseneck from PVC..  The mast 1 1/2" pipe cut to length and then reinforced with treated wood and the goose neck is from a 1 1/2 x 1 1/4" tee.  My boom was supposed to be a 1 1/4" hardwood dowel but HD and Lowes both have ceased carrying that size (where i live) so the closest I could come was a poplar dowel 1 3/8" in diameter that I sanded down and have a nice fit into the 1 1/4" side of the tee.

I also found that my back couldnt take much more bending over to work on the inside so I made some 24 high saw horses that bring the boat to a perfect (for me) height to save my back.  Cute little things.

Today I attached to rudder.  Put the pintles & gudgeons on and took a lot of time to make sure I got it right. I think I did.  The rudder and tiller look really nice.  Hope they work as well as they look.

Now I am at the stage of what next? It appears that a dinghy dolly will be that project.  I havent found actual plans for one but have seen photos and  figure that I can make something close to what Ive seen that will fit the bill.

There is one more go round with epoxy filling some dings and gouges and no doubt some sanding after that.  Then it will be a clean up and Helmsman for the inside.  Really cant wait to do that finishing.
 

 




Related Posts by Categories

0 komentar:

Posting Komentar